[드라이버] APM

마루 0 1,526 2010.01.06 12:40
IBM Software

OS/2 Device Driver Pak On-Line
OS/2 Component Updates
OS/2 Base Device Driver Updates
Advanced Power Management BIOS level 1.2 Support
Last updated on 07 Jan 1998 at 01:28pm
Product Information

Bus Type: EISA, ISA, Microchannel, PCI

Product Chip / Technologies: All
Driver Information
Primary

Product Compatibility Information:

    * OS/2 Warp 4 (Merlin)

This product is supported by IBM. For Technical Assistance, please refer to the following sources:

   1. Any README documentation contained within the driver.
   2. Technical reference material shipped with your device / system,
   3. The Users Guide to OS/2 Warp, and other reference material contained within the OS/2 Warp product,
   4. The IBM Software home page for technical support information in your country.

Get helpful instructions on downloading the Primary Driver package, or download the Primary Device Driver package named APM.SYS. The APM.SYS driver package dated 12/05/97 6:23p is 11,412 bytes. As a reference, it will take approximately 1 minutes to download this package using a 14.4 modem. Your download time will vary depending on your modem speed, network load, etc..

You may find additional information (such as "ReadMe"s) in the Device Driver Parts List.

This APM.SYS device driver supports systems with Intel Advanced Power Management BIOS level 1.2, as well as systems running earlier versions of APM BIOS. This driver includes bug fixes for APM and support for the new functionality of APM v1.2. It will be included in OS/2 Warp 4 Fix Pack 6, along with a new Power Object to take advantage of the new functionality. To install:

   1. In an OS/2 Window, enter cd os2boot
   2. Then enter ren apm.sys *.old If this step fails APM has not been previously installed. To install APM:
         1. Open a new OS/2 Window, enter e config.sys
         2. Search for the line DEVICE=C:OS2MDOSVMOUSE.SYS, where C: is the boot drive.
         3. Preceeding the VMOUSE line, add the line DEVICE=C:OS2BOOTAPM.SYS, where C: is the boot drive.
         4. Save the file, exit the editor and close the OS/2 Window.
   3. Download the file APM.SYS to os2boot
   4. Reboot

The Device Listing shows other hardware that also use the APM.SYS driver.
Manufacturer Information
OS/2 Base Device Driver Updates


WWW site: www.ibm.com.
General enquiries: 1-800-IBM-CALL.

NOTE: All telephone numbers are in the USA, unless otherwise specified. If you are calling from outside the USA and Canada, please prefix all numbers with the correct international dialing code and country code.

Please contact the manufacturer or visit their WWW site to obtain contact information local to your country.



****
머린 용입니다.

Comments

Category
State
  • 현재 접속자 95 명
  • 오늘 방문자 725 명
  • 어제 방문자 921 명
  • 최대 방문자 4,250 명
  • 전체 방문자 972,783 명
  • 전체 게시물 2,370 개
  • 전체 댓글수 3,989 개
  • 전체 회원수 47 명

- 쇼핑몰 : Softbox
Facebook Twitter GooglePlus KakaoStory NaverBand